Steering Repair & Wheel Alignment — serving clients from Nairobi
This page is about how Nairobi driving conditions affect steering repair & wheel alignment specifically, and what that means for vehicles brought to us from Nairobi.
Nairobi driving is stop-start traffic, sharp speed bumps in the estates and long idling periods in the CBD. That combination is hardest on suspension bushes, engine mountings, clutch and cooling systems rather than on high-speed components.
Why Nairobi conditions matter for this repair
Nairobi driving is stop-start traffic, sharp speed bumps in the estates and long idling periods in the CBD. That combination is hardest on suspension bushes, engine mountings, clutch and cooling systems rather than on high-speed components.
Because of that, the components we most often find at fault on Nairobi vehicles are steering rack, tie rod ends and inner racks, power steering pump and hoses.
Symptoms owners report
- The vehicle pulling to one side
- An off-centre steering wheel on a straight road
- Heavy or notchy steering
- Rapid inner or outer tyre wear
How the job is carried out
- Play test at the wheel and at each joint.
- Rack, pump and hose inspection for leakage and stiffness.
- Four-wheel alignment with camber, caster and toe recorded before and after.
Getting the vehicle to us from Nairobi
Our workshop is in Nairobi CBD on Kirinyaga Road, behind Eagle Towers, so Nairobi clients can normally drop a vehicle in the morning and collect the same day for routine work.
If the vehicle is not safe to drive, tell us before you set off and we will advise on recovery rather than risk further damage on the journey.
Booking and contact
Our workshop is at Nairobi CBD, Kirinyaga Road, behind Eagle Towers, open Monday to Saturday 7:30am to 6:00pm. We are based in Nairobi; there is no second branch.
Call +254796479403 or message the same number on WhatsApp to confirm parts and a workshop slot before you travel.
Frequently asked
Do you have a branch in Nairobi?
Our single workshop is in Nairobi CBD on Kirinyaga Road, behind Eagle Towers.
Why did my alignment not last?
Almost always because a worn joint or bush was not replaced first. Geometry cannot be set on loose components.